Stern Bracket - Manual Tilt Models; Clamp Screw; Stern Bracket Disassembly (Manual Tilt) - Evinrude E-TEC E40DRLSCB Service Manual

STERN BRACKET –
Manual Tilt Models

Clamp Screw

Inspect clamp screw assemblies). Replace swivel
plate and retainer if bent or loose. To install a new
swivel plate, remove screw and old plate. Apply
Locquic Primer to the threads of the screw and
allow it to dry four to five minutes. Then apply
Ultra Lock to threads. Install a new swivel plate
with screw and tighten securely.
Stern Bracket Disassembly
(Manual Tilt)
Remove bumpers from the upper mount retaining
screws.
1
1. Bumpers
Remove screws, upper mount, and ground lead
from the bracket.
1
3
1. Screws
2. Upper mount
3. Ground lead
STERN BRACKET –MANUAL TILT MODELS
Slide the pivot shaft and upper thrust washer out
of the swivel bracket.
1. Upper thrust washer
Using an appropriate tool, pry the upper and lower
seals from the swivel bracket.
COA2949
2
Loosen the steering friction screw while pushing
COA2950
outward on the steering friction pin. When the pin
MIDSECTION
1
COA2956
COA2957
12
COA2958
247