Evinrude E-TEC E40DRLSCB Service Manual page 269

Install the handle end of the throttle cable. Snap
the throttle cable trunnion into the recess in the
handle. Install the retainer clip.
1. Throttle cable trunnion
2. Retainer
Push the throttle cable pin through the end of the
throttle cable.
1
1. Pin
Lubricate end of the pin, guides, rollers, helix
halves, and inner handle guide slot with Moly
Lube.
1 2
1. Helix halves
2. Rollers
3. Guides
1
2
006683
006712
3 2 1
COA2674
TILLER HANDLE SERVICE – LONG HANDLE
Place the guides over the roller pin and into the
slots of the inner handle. Place the rollers on the
ends of the roller pin.
1. Roller
Assemble the helix halves on the handle and slide
the grip over the helix.
Carefully pull trim switch wires through inner tiller
handle as twist grip assembly is installed.
1
1. Trim switch wiring
Install trim switch connector. Refer to CONNEC-
TOR SERVICING on p. 148.
MIDSECTION
1
006670
006718
12
006677
267