Electrical Harness Connections; Water Pressure Gauge; Seal View; Water Pressure Hose Fitting View - Evinrude E-TEC E40DRLSCB Service Manual

INSTALLATION AND PREDELIVERY
OUTBOARD RIGGING

Electrical Harness Connections

Place the wiring harness through notch in lower
motor cover and route to the recess in the fly-
wheel cover. Secure the cable with a tie strap as
shown:
1
1. Recess
2. Tie strap
Before installing electrical connectors, check that
the seal is in place. Clean off any dirt from con-
nectors. Apply a light coat of Electrical Grease
to the seal.
1. Seal
Arrange connectors in flywheel cover.
50
Install electrical cover and secure with screws.
2
IMPORTANT:
wires are not pinched, cannot contact flywheel,
and do not interfere with moving throttle or shift
002011
linkages.

Water Pressure Gauge

If a mechanical water pressure gauge is used,
install the water pressure hose fitting in the cylin-
™
der block. Use Pipe Sealant with Teflon,
P/N 910048, on the threads of the hose fitting.
Refer to installation instructions supplied with
gauge.
1
42079A
1. Water pressure hose fitting
001999
BE SURE all harnesses and
002102
1
002461