Evinrude E-TEC E40DRLSCB Service Manual page 368

EMM CIRCUIT/SENSOR
51 Fuel injector circuit #1 OPEN
52 Fuel injector circuit #2 OPEN
53 Fuel injector circuit #3 OPEN
57 High RPM with low TPS setting
58 Operating temperature not reached
61 Fuel injector circuit #1 SHORTED
62 Fuel injector circuit #2 SHORTED
63 Fuel injector circuit #3 SHORTED
81 Ignition timing circuit #1 OPEN
82 Ignition timing circuit #2 OPEN
83 Ignition timing circuit #3 OPEN
90 Water injection solenoid SHORTED
91 Fuel pump circuit OPEN
93 Water injection solenoid OPEN
94 Fuel pump circuit SHORTED
101 Ignition timing circuit #1 SHORTED
102 Ignition timing circuit #2 SHORTED
103 Ignition timing circuit #3 SHORTED
117 Critical LOW OIL detected
NOTE: Always note service codes before clearing codes. Clear stored codes using diagnostic software. Clearing some codes requires turning EMM "OFF" and then "ON" again.
page 2
Rev 09/07
DASHBOARD
EMM LED DISPLAY GAUGE WARNING
DISPLAY
LED 2: ON (Running) -
LED 2: ON (Running) -
LED 2: ON (Running) -
CHECK ENGINE
LED 3: FLASHING
(FLASHING)
LED 3: OFF (Cranking) / ON (Running) -
LED 2: ON (Running) -
LED 2: ON (Running) -
LED 2: ON (Running) -
LED 2: ON (Running) -
LED 2: ON (Running) -
LED 2: ON (Running) -
LED 2: ON (Running) -
LED 2: ON (Running) -
LED 2: ON (Running) -
LED 2: ON (Running) -
LED 2: ON (Running) -
LED 2: ON (Running) -
LED 2: ON (Running) -
LED 4: ON (Running) NO OIL
TIME TO
SENSOR: CIRCUIT VOLTAGE / RESISTANCE (Ω) / INFORMATION
ACTIVATE
2 seconds
Check injector/circuit resistance—2 to 3 Ω @ 72°F (22°C).
2 seconds
2 seconds
TPS < 5% and RPM > 3000. Engine SHUTDOWN. Will NOT restart until code has been cleared. The problem could be caused by
10 seconds
uncontrolled fuel entering the engine. DO NOT attempt to start the outboard until the problem has been found and repaired.
Engine temperature < 104° F (40° C) with engine speed < 2300 RPM.
10 minutes
8 seconds
Check injector/circuit resistance—2 to 3 Ω @ 72°F (22°C).
8 seconds
8 seconds
10 instances
10 instances EMM counts failed ignition events. Check wiring. Test with known good ignition coil.
10 instances
8 seconds
8 seconds Check pump/circuit resistance—2 to 3 Ω @ 77°F (25°C).
8 seconds
2 seconds Check pump/circuit resistance—2 to 3 Ω @ 77°F (25°C).
20 instances
20 instances EMM counts failed ignition events. Check wiring. Test with known good ignition coil.
20 instances
4800 Pulses (2 Cyl) EMM counts oil pump pulses after LOW OIL switch closes. Engine limited to 1200 RPM.
6000 Pulses (3 Cyl) Stop outboard and add oil to tank. Warning resets after three oil pump pulses.
Check thermostat and pressure relief valve.
Check circuit resistance—295 Ω ± 20 @ 77°F (25°C).
Check circuit resistance—295 Ω ± 20 @ 77°F (25°C).