Service Specifications - Evinrude E-TEC E40DRLSCB Service Manual

INTRODUCTION

SERVICE SPECIFICATIONS

SERVICE SPECIFICATIONS
Full Throttle
Operating Range RPM
Power
Idle RPM in Gear
Idle RPM in Neutral
Test Propeller
Weight
(may vary depending
on model)
Lubrication
Engine Type
Displacement
Bore
Stroke
Standard Bore
Top Crankshaft Journal
Center Crankshaft Journal
Bottom Crankshaft Journal
Rod Crankpin
Piston Ring End Gap, Both
Fuel/Oil Control
Starting Enrichment
Minimum (High) Fuel Pressure
Minimum Fuel Lift
Pump Pressure
Maximum Fuel Inlet Vacuum
Minimum Octane
Additives
10
40 – 65 HP E-TEC Models
40 HP – 5000 to 6000 RPM
50 HP – 5500 to 6000 RPM
60 HP – 5500 to 6000 RPM
650 HP – 5500 to 6000 RPM
40 HP (30 kw) @ 5500 RPM
50 HP (37 kw) @ 5750 RPM
60 HP (45 kw) @ 5750 RPM
65 HP (45 kw) @ 5750 RPM
800 ± 50 EMM Controlled
750 ± 50 EMM Controlled
(RL) Models: 232 lbs. (105 kg)
(PL) Models: 240 lbs. (109 kg)
Evinrude/Johnson XD100, XD50, XD30; or
NMMA TC-W3 certified
In-line, 2 Cylinder, Two-Cycle
52.7 cu. in. (864 cc)
3.601 in (91.47 mm)
2.588 in. (65.74 mm)
3.6005 to 3.6015 in. (91.45 to 91.48 mm)
To bore oversize, add piston oversize dimension to standard bore
2.1870 to 2.1875 in. (55.55 to 55.56 mm)
2.1870 to 2.1875 in. (55.55 to 55.56 mm)
1.5747 to 1.5752 in. (40.0 to 40.01 mm)
1.3757 to 1.3762 in. (34.94 to 34.96 mm)
0.011 to 0.023 in. (0.28 to 0.58 mm)
24 to 28 psi (165 to 193 kPa)
87 AKI (R+M)/2 or 90 RON
®
2+4 Fuel Conditioner, Fuel System Cleaner
Use of other additives may result in engine damage.
See Fuel Requirements on p. 53 for additional information
P/N 382861
EMM Controlled
EMM Controlled
3 psi (21 kPa)
4 in. Hg.