Stator Service; Flywheel Installation - Evinrude E-TEC E40DRLSCB Service Manual

Stator Service

Disconnect stator harness connector.
Remove three allen head screws to remove sta-
tor.
1
1. Stator screws
To install stator, position stator on cylinder block.
Apply Nut Lock to screw threads. Install screws
and tighten in crossing pattern to a torque of 84 to
106 in. lbs. (9.5 to 12 N·m).

Flywheel Installation

Install the outer edge of flywheel key parallel with
centerline of crankshaft.
1. Flywheel key
FLYWHEEL AND STATOR SERVICING
Thoroughly clean the crankshaft and flywheel
tapers with Cleaning Solvent
Align the flywheel keyway and install flywheel.
Coat the threads of a new flywheel nut with Triple-
006486
Guard grease. Install the washer and nut and
tighten to a torque of 100 to 115 ft. lbs. (136 to
156 N·m).
1
Replace flywheel cover and recoil starter (rope
start models).
IMPORTANT:
wheel removal or replacement. Refer to TIMING
DRC2116 ADJUSTMENTS on p. 142.
ELECTRICAL AND IGNITION
and let dry.
™
Check ignition timing after fly-
002093
7
002090
141