Evinrude E-TEC E40DRLSCB Service Manual page 142

ELECTRICAL AND IGNITION
FLYWHEEL AND STATOR SERVICING
Disconnect wiring harness and remove wiring
from cover.
1. MWS harness
Remove fuse holder from flywheel cover.
1
1. Fuse holder
Lift flywheel cover to remove.
140
Use Flywheel Holder, P/N 771311, or equivalent,
and a 1 5/16 in. socket to remove flywheel nut.
Discard flywheel nut.
1
002086
Apply Moly Lube grease to the threads of the
puller pressing screw, P/N 307637, and the center
hole of the crankshaft.
Assemble the following components from Univer-
sal Puller Set, P/N 378103:
•
Body, P/N 307636
•
Screw, P/N 307637
•
Handle, P/N 307638
•
Three screws P/N 309492
•
Three washers, P/N 307640
002094 Put the puller on flywheel with body flat side up.
Attach the puller body with the three shoulder
screws and washers. Hold puller body with han-
dle, and tighten pressing screw until flywheel
releases. Turn the center screw and lift the fly-
wheel off of the crankshaft.
1
002087
1. Universal puller
002088
002089