Evinrude E-TEC E40DRLSCB Service Manual page 307

hydraulic passages during assembly. Tape the
trim/tilt piston rods before painting.
WARNING
There may be high pressure behind some
power trim valves. To avoid injury when
removing manual release valve, be sure to
cover valve with a shop cloth until the
pressure is released. Wear safety glasses.
IMPORTANT:
Before removing manual release
valve, relieve pressure by fully extending cylinder.
Screw the manual release valve in. Remove the
retaining ring using a small pick or screwdriver.
Remove the manual release valve.
Inspect the manual release valve. Discard the O-
rings on the housing.
Remove the four large motor flange retaining
screws. Remove the motor and discard O-ring.
002528
Remove drive coupler from either the motor or the
pump assembly.
002529
TRIM AND TILT
SERVICING
002530
002531
002532
14
305