Oil Tank Assembly Removal; Oil Tank Assembly Installation - Evinrude E-TEC E40DRLSCB Service Manual

Oil Tank Assembly
Removal
Disconnect the battery cables at the battery.
Remove engine covers and air silencer.
Disconnect the electrical connector to the oil injec-
tion pump and manifold assembly.
1
1. Oil pump connector
IMPORTANT:
Note oil distribution hose rout-
ings before proceeding with disassembly.
Remove oil distribution hoses from the crankcase
fittings.
Remove oil tank retaining screws.
1
1. Screw
1. Screws
Installation
Position oil tank assembly on powerhead. Clean
mounting screws and apply Nut Lock to threads.
Install screws and tighten to a torque of 30 to 42
in. lbs. (3.5 to 5 N·m).
Install protective sleeves and route oil distribution
006574
hoses from the oil distribution manifold to the
crankcase oil delivery fittings. Refer to OIL SUP-
PLY DIAGRAMS on p. 177. Secure oil hoses to
crankcase fittings with tie straps.
1. Tie strap
Run outboard and check for leaks. Use Evinrude
Diagnostics software to activate "Oil Prime."
Check oil flow through oil distribution hoses.
006576
Check oil system operation and routing of oil sys-
tem hoses.
Repair any oil leaks and kinked or misrouted
hoses. Install air silencer and engine covers.
OILING SYSTEM
OIL COMPONENT SERVICING
1
006488
1
9
006573
187