Exhaust Housing Installation - Evinrude E-TEC E40DRLSCB Service Manual

Table of Contents

EXHAUST HOUSING SERVICE

Exhaust Housing Installation

Bring the exhaust housing into position with the

stern bracket.

Exhaust Housing

Apply Nut Lock to threads of the upper mount

screws. Install the screws and place ground lead

under the center screw. Tighten screws to a

torque of 18 to 20 ft. lbs. (24 to 27 N·m).

1. Ground lead

Place lower thrust washer on the steering shaft

and place the lower front mount into position.

1. Thrust washer

2. Lower front mount

Install lower side mount covers. Install and tighten

the screws in stages to a torque of 16 to 18 ft. lbs.

(22 to 24 N·m) following sequence shown.

Torque sequence

Install gearcase. Refer to Gearcase GEARCASE

REMOVAL AND INSTALLATION on p. 276.

Install powerhead. Refer to Powerhead POWER-

HEAD INSTALLATION on p. 225.