Powerhead Assembly; Crankshaft Assembly; Bearings - Evinrude E-TEC E40DRLSCB Service Manual

Inspect crankshaft rod bearings for excess wear,
nicks, or scratches. Replace if necessary.
POWERHEAD
ASSEMBLY
IMPORTANT:
assemblies unless a pressing operation is called
for. All internal components must be perfectly
clean and lightly coated with outboard lubricant.
IMPORTANT:
gaskets, seals, and O-rings during assembly.

Crankshaft Assembly

Oil the end of the crankshaft. Use Crankshaft
24377
Bearing/Sleeve Installer, P/N 338647, and place a
new lower main bearing onto crankshaft with let-
tered side facing the tool. Install bearing until it
seats on the crankshaft.
Oil the end of the crankshaft. Use Crankshaft
Bearing/Sleeve Installer, P/N 338647, to drive a
new sleeve onto the crankshaft until the installer
contacts the lower main bearing.
POWERHEAD

POWERHEAD ASSEMBLY

Proceed slowly. Make no forced
Use new wrist pin retaining rings,
002029
11
002030
213