Table of Contents
Advertisement
Installation
Thread starboard end of tilt tube into the spacer.
Thread the adapter onto port end of tilt tube.
Use a wood or leather mallet to tap the tilt tube
into position.
Make sure the lock tab is in correct position.
1. Lock tab
Install the starboard locknut.
Replace locknut if definite resistance is
not felt.
Tighten starboard tilt tube nut to a torque of 45 to
50 ft. lbs. (61 to 68 N·m).
30743
Replace steering cable wiper nut on port end of tilt
1
tube.
30742
MIDSECTION
TILT TUBE SERVICE
WARNING
30741
12
241
Advertisement
Table of Contents
Troubleshooting
