Packard Connectors - Evinrude E-TEC E40DRLSCB Service Manual

Table of Contents

The J2 connector of the EMM is a AMP Power

Timer Series connector.

Use a screw driver to open latch. Pull connector

Push connector until seated in plug. Close latch

1. J2 connector

2. Latch (closed)

Terminal Removal

Use Terminal Release Tool, P/N 351413, to

release BOTH locking mechanisms of connector.

Pull terminal from housing.

1. Locking mechanism(s)

1. Terminal release tool

Terminal Installation

Align terminal with connector housing and push

terminal with seal into connector housing until

2. Terminal with seal

test probes and adapters when testing compo-

nents fitted with these terminals.

Lift latch(s). Remove connector.

Confirm the seal is in place. Push connector onto

housing until latched.

ELECTRICAL AND IGNITION

CONNECTOR SERVICING

Always use the appropriate meter

Troubleshooting