Viavi Xgig User Manual page 82

Chapter 3, Getting Started with Xgig TraceControl
You will be prompted to enter the user name and password for the chassis web page. The
3
default user name is
changed, check with your system administrator for the correct user name and password.
To start tuning, press the
4
have not selected all the ports on the blade to be included in the domain, the unselected ports
will be grayed out and therefore will not be tuned when you click the
The tuning process optimizes the receiver. This process takes a variable amount of time and
5
can last up to 30 seconds. During tuning, the TraceControl LEDs will flash red while the
optimal parameters are determined for the receiver. Upon completion of a successful tune, the
LEDs will turn yellow. A page will display showing Tuning has started for the blade/ports and
the Equalization page automatically returns after a brief period. The Tuning result is shown on
the Equalization page.
6 Manually reset the TraceControl software LEDs. Right-click the LEDs and select
LED's and Link Speed Status
Reset LED's, Link Speed Status, and Counters
The optimized settings will take effect immediately. If you press
capture in TraceControl, the newly optimized settings will be used.
Notes for Tuning
1 The optimized values determined by Tuning become invalid if any of the following is true:
a The blade is moved to a different chassis or slot
68
and the default password is
JDSU
button on the
Tune Blade X Equalization Settings
from the menu. You can also reset the LEDs by clicking on the
Xgig Tuning and Equalization
If the defaults have been
JDSUsnt.
button.
Tune
button in the toolbar.
Apply Configuration
Xgig Analyzer User's Guide
web page. If you
Reset
or start a