Viavi Xgig User Manual page 280

Chapter 13, Configuring Xgig TraceView
SAS-2 and SAS-3, OOB Decodes
The following table describes how TraceView uses the timing measurements of idles to determine
if the signal is good for each type of event for SAS-2.
Table 19: SAS-2 and SAS-3, OOB Decodes
OOB Decode
COMINIT/ COMRESET detected
COMINIT/ COMRESET (incorrect
timing) detected
COMINIT/ COMRESET Begin
COMINIT/ COMRESET End
COMSAS detected
COMSAS (incorrect timing)
detected
COMSAS Begin
COMSAS End
COMWAKE detected
COMWAKE (incorrect timing)
detected
COMWAKE Begin
COMWAKE End
SATA Port Selection OOB
detected
OOB Begin
OOB End
266
Event Description
This event is set when the timing of the first, second, third, and fourth
D.C. idle time of a received COMINIT/ COMRESET OOB signal is
within the range specified in
This event is set when the timing of the second or third or fourth D.C.
idle time of a received COMINIT/ COMRESET OOB signal is not within
Table 15
the range specified in
This event marks the beginning of the COMRESET /COMINIT OOB
signal.
This event marks the end of the COMRESET/COMINIT OOB signal.
This event is set when the timing of the first, second, third, and fourth
D.C. idle time of a received COMSAS OOB signal is within the range
Table 15
specified in .
This event is set when the timing of the second or third or fourth D.C.
idle time of a received COMSAS OOB signal is not within the range
Table 15
specified in .
This event marks the beginning of the COMSAS OOB signal.
This event marks the end of the COMSAS OOB signal.
This event is set when the timing of the first, second, third, and fourth
D.C. idle time of a received COMWAKE OOB signal is within the range
Table 15
specified in .
This event is set when the timing of the second or third or fourth D.C.
idle time of a received COMWAKE OOB signal is not within the range
Table 15
specified in .
This event marks the beginning of the COMWAKE OOB signal.
This event marks the end of the COMWAKE OOB signal.
This event is set when a SATA Port Selection OOB signal is detected.
This event marks the beginning of the OOB sequence.
This event marks the end of the OOB sequence.
Filter And Hide
Table 15
.
.
Xgig Analyzer User's Guide