Installation - Viavi Xgig User Manual

Chapter 1, Introduction

Installation

Below is an overview of the installation process. For system requirements and complete
installation instructions for the Xgig Analyzer software, refer to the Xgig Analyzer Software
Installation Guide.
The general steps are outlined below:
Check to make sure your system meets the system requirements for installing Xgig Analyzer
1
software.
2 Install any new hardware in your Xgig chassis. Refer to the documentation that comes with the
new blade.
3 Installation requires the removal of older versions of software. Remove all older versions of
GTX, IBT, Expert, or Xgig software before installing the new version.
Install the new Xgig Analyzer software on your PC system.
4
If the new version requires an upgrade to the Xgig chassis, you will receive a separate USB
5
memory drive to upgrade the software on the Xgig chassis. Xgig remote analyzer system
hardware is shipped with all required software installed. However, upgrading to a new version
of Xgig Analyzer software may require an upgrade of software at the Xgig system. Refer to
the Xgig Family Hardware Guide, the Xgig5000 Family Hardware Guide, or the Xgig1000
Hardware Guide for more information on installing software on the Xgig chassis.
10
Xgig Analysis and Control Software
Xgig Analyzer User's Guide