Viavi Xgig User Manual page 233

Working With Domains
Discover Different Subnets
To select Sync Groups on a different subnet, enter the IP Address or DNS name in the
field and press
Sync Groups on the same remote subnet will be added to the left panel.
Sync Groups and Domains
All Sync Groups discovered on the local subnet are displayed in the upper left panel. When you
select a Sync Group, its chassis, blades and ports display in the right panel showing all available
ports. If multiple chassis are cascaded to form a single Sync Group, the name and address of the
master chassis within the Sync Group displays in the
chassis cascaded to the master do not display. However, you can use the name or address of a slave
chassis in the
The
Sync Group Domain(s)
domain can be selected and used. When you select a domain where the ports in the domain contain
no valid data, the
capture data, a message appears in the Port Viewing and Selection area informing you that there is
no domain for TraceView to interpret for the selected Sync Group.
The
Sync Group Domain(s)
links and ports within the Sync Group that comprise the domain are listed within the tree,
providing a visual description of the domain contents. Ports may be listed directly under the Sync
Group or listed under links if a link has been created for the domain. Links only apply to a single
protocol where several port-pairs can be aggregated into a single physical link (for example,
wide-port SAS). Links, like domains, are created in TraceControl. See
Links, and Ports" on page 33
Important: A valid capture is a capture that was previously made on the port. The domain
that includes the port must still be intact for the capture to be valid; that is, the domain cannot
be deleted or the ports assigned to a different domain. There must be no reboot or Sync Reset
operation on the hardware since the last capture was made for the capture to remain valid.
Xgig Analyzer User's Guide
Discover (top of the dialog). The specific Sync Group you requested and all other
Address area to discover a Sync Group on the subnet.
area lists all the domains of the selected Sync Group. Only one
button is grayed out. If none of the ports within the Sync Group contain valid
OK
area shows the domain as a tree structure. The Sync Group and all
for more information on creating links.
Chapter 12, Getting Started with Xgig TraceView
Sync Group(s) area. The addresses of slave
"Sync Groups, Domains,
Address
219