Dialogs Tab - Viavi Xgig User Manual

Chapter 19, Xgig TraceView Tools
•
Dialogs
Use these settings to prevent TraceView from displaying certain dialog messages.
• Expert/Protocol Decodes
Use these settings to set the level of integration with Xgig Expert.
• Ports Side-by-Side Configuration
Use these settings to set configuration options in the port side-by-side display of trace data,
including the option to display one Dword per line.
•
Search
Use these settings to control the search methods used in the

Dialogs Tab

•
Prompt when the network connection to the remote chassis is lost
If enabled, TraceView will present a dialog when the connection to the Xgig chassis is lost and
you are viewing data directly from an Xgig blade hardware buffer.
• Prompt to reload the trace when Xgig Expert added more
decode information
If enabled, TraceView presents a dialog box to reload the trace after a trace has been examined
by the Expert application. The Expert application can add more detailed decode information,
but you must reload the trace to see this information in TraceView.
• Prompt before clearing the Quick Filter/Quick Hide lists
If enabled, TraceView presents a confirmation message when you press the
Quick Filter List or Quick Hide List dialog box.
•
Prompt when duplicate Bookmarks are created
If enabled, TraceView presents a confirmation message when you attempt to create a
bookmark for an event that has already been bookmarked.
•
Prompt when CurrentProtocols.pmd was modified
If enabled, TraceView presents a dialog box alerting the user that the compiled decode library
used for searching might match different events than what is being decoded and shown in the
user interface.
• Prompt on mismatching chassis AppKit
If enabled, TraceView presents a dialog box alerting the user that the compiled decode library
on the chassis might match different events than what is being decoded and shown in the user
interface.
• Save/View non-overlapped data
By default, this is unchecked. This check box controls two different things. First, it shows/
hides the
non-overlapped data while saving. The
checked. Once the
non-overlapped data, or click it so that it is depressed to see overlapped data.
408
tab
tab
tab
T1/T2 button in TraceView's menu bar. Secondly, it excludes/includes
T1/T2 button is visible, you can click it so that it is not depressed to view
tab
Quick Find
T1/T2 button is displayed only when the check box is
TraceView Options
dialog.
Clear button in the
Xgig Analyzer User's Guide