Viavi Xgig User Manual page 144

Chapter 4, Xgig TraceControl Capture Configuration
Select
4
window.
When the trigger event occurs, the buffer will be filled with post-trigger data. When the last
segment is filled, the capture will stop.
Previous Single Burst Configurations
When using a configuration file that was created with Analyzer 4.6 or earlier using the burst
capture feature for a single burst, TraceControl opens the configuration in the
mode and sets the post fill to 100%. You must select the Segment Capture Mode manually in the
TraceControl main window.
Continuous Burst
To fill the buffer with a series of burst events, follow these steps:
Select
1
Pre-Triggered and Triggered states.
Define the trigger event in the
2
Select the post trigger fill level you want. The default is 50%.
3
4 Select
drop-down menu in the TraceControl main window. To continue to wrap until the user clicks
the stop button, select
stop or saving
Previous Continuous Burst Configurations
When using a configuration file that was created with Analyzer 4.6 or earlier using the burst
capture feature for a continuous burst, TraceControl uses the
select the Segment Capture Mode manually in the TraceControl main window. You must also
check the
under the
130
Start Capture on All Segments from Selected to Last
from the
Trigger Trigger Mode
Transition Editor
Start Capture on All Segments from Selected to Last
Tools > Automated Options
check box.
Restart capture after stop or saving
Tools menu.
from the TraceControl main
drop-down menu. This two-state trigger includes
.
from the Segment select
, then select the
Trigger
checkbox in the Automated Options
Capture and Trigger Setup
Trigger trigger
Restart capture after
trigger mode. You must
dialog
Xgig Analyzer User's Guide