Viavi Xgig User Manual page 391

Using Template Editor
•
FC-SW Accept Interpretation
Shows up on FC-SW (Fibre Channel Switch Fabric Internal Link Service) Accept frames. It
contains a list of the possible Switch Link Service Accept frame formats.
•
FC-GS Accept Interpretation
Shows up on FC-GS (Fibre Channel Generic Service) Accept frames. It contains a list of the
possible Generic Service Accept frame formats.
• ATA Output Interpretation
Shows up on SATA Data and Response (Reg: Host->Dev) FIS. It contains a list of all possible
ATA commands.
•
FCLP Data Interpretation
Shows up on SCSI Data frames for SAS, SATA and Fibre Channel. It contains a list of all
possible FC-AE-FCLP Data frames.
When appropriate, some of the global Decode Switches described in the section
Switches" on page 385
Proper Use of Template Editor Decode Switches
Be aware that the Decode Switches are a tool to help you create templates, but the switches you set
aren't used by TraceControl or TraceView to trigger/filter or search for a specific frame.
For example, assume you create a
by setting the switch
Periph Qualifier
Xgig Analyzer User's Guide
are also visible in the Template Editor.
SCSI Inquiry Data
SCSI Data Interpretation
field to 0x1 Not Connected
Chapter 16, Xgig TraceView Template Editor
template from the
to SCSI Inquiry Data . You then set the 3-bit
, you end-up with a template shown in Figure 172.
"Decode
Any SCSI Data template
377