Ipv6 Pim Configuration Examples; Ipv6 Pim-Dm Configuration Example - HP MSR ASM Configuration Manual

IPv6 PIM configuration examples

This section provides examples of configuring IPv6 PIM on routers.

IPv6 PIM-DM configuration example

Network requirements
The receivers receive VOD information through multicast. The receiver groups of different organizations
form stub networks, and at least one receiver host exists in each stub network. The entire IPv6 PIM domain
operates in the dense mode.
Host A and Host C are IPv6 multicast receivers in two stub networks N1 and N2.
MLDv1 runs between Router A and N1 and between Router B, Router C, and N2.
Figure 95 Network diagram
Table 27 shows the interface and IPv6 address assignment, and network topology scheme.
Table 27 Interface and IPv6 address assignment
Device
Router A
Router A
Router B
Router B
Router C
Router C
Interface
Ethernet 1/1
Serial 2/0
Ethernet 1/1
POS 5/0
Ethernet 1/1
POS 5/0
342
IPv6 address
1001::1/64
1002::1/64
2001::1/64
2002::1/64
2001::2/64
3001::1/64