Configuring Source Ports For The Local Mirroring Group - HP MSR Series Configuration Manual

Step
2. Create a local mirroring
group.
NOTE:
A local mirroring group takes effect only after you configure a monitor port and source port for it.
The following matrix shows the feature and router compatibility:
Feature
Creating a
local
mirroring
group

Configuring source ports for the local mirroring group

Either you can configure a list of source ports for a mirroring group in system view, or you can assign only
the current port to the mirroring group as a source port in interface view. The two methods lead to the
same result.
Configuration restrictions and guidelines
When you configure source ports for a local mirroring group, follow these restrictions and guidelines:
A mirroring group can contain multiple source ports.
•
A port can belong to only one mirroring group. On devices that support mirroring groups with
•
multiple monitor ports, a port can serve as a source port for multiple mirroring groups, but the port
cannot be a monitor port at the same time.
Configuring source ports
Step
1. Enter system view.
Configure source ports.
2.
Command
mirroring-group group-id local
MSR900 MSR93X
Yes Yes
Value Value
range for range for
the the
number: 1 number: 1
to 5. to 5.
Command
system-view
•
(Method 1) In system view:
mirroring-group group-id
mirroring-port
mirroring-port-list { both |
inbound | outbound }
•
(Method 2) In interface view:
MSR20-1X MSR20
Yes
Yes
Value
Value
range for
range for
the
the number:
number: 1
1 to 5.
to 5.
a. interface interface-type
interface-number
b. mirroring-group group-id
mirroring-port { both |
inbound | outbound }
167
Remarks
No local mirroring group
exists by default.
MSR30 MSR50
Yes Yes
Value Value
range for range
the for the
number: 1 number:
to 5. 1 to 10.
Remarks
N/A
Use either method.
By default, no source port is
configured for a local mirroring
group.
By default, a port is not a source
port of any local mirroring group.
MSR1000
Yes
Value
range for
the number:
1 to 5.