Show Controllers Fabricq Queue - Cisco XR 12000 Command Reference Manual

show controllers fabricq queue

show controllers fabricq queue
To display information about the hardware queues of the performance route processor chopper and assembler
FPGAs, use the show controllers fabricq queue command in administration EXEC mode.
show controllers fabricq queue [detail] [location node-id]
Syntax Description
detail
location node-id
Command Default
Information for all performance route processors on the router is displayed
Command Modes
Administration EXEC
Command History
Release
Release 3.2
Usage Guidelines
Use the show controllers fabricq queue command to display information about packet queues. Specifying
a location displays information only if that location is an RP.
This command is intended for use while performing debugging procedures.
Task ID
Task ID
root-system
Examples The following is detailed sample output from the show controllers fabricq queue command for the location
0/1/CPU0:
RP/0/0/CPU0:router# admin
RP/0/0/CPU0:router(admin)# show controllers fabricq queue detail location 0/1/CPU0
Location 0/1/0:
To Fabric Queue Stats:
----------------------
Slot
Low Priority:
Cisco IOS XR Advanced System Command Reference for the Cisco XR 12000 Router, Release 4.3.x
112
(Optional) Displays detailed statistical information.
(Optional) Displays statistical information for the designated node. The node-id
argument is entered in the rack/slot/module notation.
EnQueued DeQueued Cur-Entrys Max-Entrys
Modification
This command was introduced.
Operations
read, write
Blocked
Fabric Management Commands
BP count
OL-28456-02