show uidb data
Command History
Release
Release 3.2
Release 3.5.0
Release 3.7.0
Usage Guidelines
Use the show uidb index command to display micro-IDB index data information including, from a software
perspective, features that are enabled on a selected interface.
Task ID
Task ID
cisco-support
Examples
The following example shows the output of the show uidb data command:
RP/0/0/CPU0:router# show uidb data shadow ingress gigabitEthernet 0/2/4/4 loc 0/2/CPU0
--------------------------------------------------------------------------
Location = 0/2/CPU0
Ifname/Ifhandle = GigabitEthernet0_2_4_4 / 0x12800a0
Index = 5
Pse direction = INGRESS
============================================
*
--------------------------------------------
RSM STATUS: 0x7c000000
-> used: 0x1f
->dirty: 0x00
->badck: 0x00
-> prog: DONE
->count: 0
--------------------------------------------
BUNDLE IFHANDLE: 0
TUNNEL IFHANDLE: 0
L2 ENCAP: 3
============================================
General 16 bytes:
------------------------
IFHANDLE: 0x12800a
STATUS: 1
ISSU State: 0
IPV4 ENABLE: 1
IPV6 ENABLE: 1
MPLS ENABLE: 0
STATS POINTER: 0x7ffd8
Cisco IOS XR Advanced System Command Reference for the Cisco XR 12000 Router, Release 4.3.x
80
(Not programmed in hardware)
Modification
This command was introduced.
Index and operation modes were not supported.
The following keywords were added:
• shadow
• ingress
• egress
Operations
read
*
Troubleshooting Commands
OL-28456-02