Cisco XR 12000 Command Reference Manual page 279

Tech-Support Commands
• show ospf vrf all border-routers
• show ospf retransmission-list
• show ospf vrf all retransmission-list
• show ospf request-list
• show ospf vrf all request-list
• show ospf flood-list
• show ospf vrf all flood-list
• show ospf maxage-list
• show ospf vrf all maxage-list
• show ospf bad-checksum
• show ospf vrf all bad-checksum
• show ospf standby
• show ospf vrf all standby
• show ip interface brief
• show route ipv4 summary
• show route vrf all ipv4 summary
• show ospf trace all
• show logging process ospf
Note • If you do not specify any options, all information is collected by default.
• Active and standby options are exclusive and only one of them can be used. When neither active or
• The no-trace option can be used with or without specifying the active or standby options.
• When standby option is specified, only ospf- related information from the standby RP is included
See the Cisco IOS XR software command references for information about these commands and descriptions
of their command output. The Cisco IOS XR software command references are located at the following URL:
http://www.cisco.com/en/US/products/ps5845/prod_command_reference_list.html
Task ID
Task ID
basic-services
OL-28456-02
standby is used, the information is collected from both RPs.
in the output. The common non-ospf information such as version, placement info, logging and so
on are not included.
Cisco IOS XR Advanced System Command Reference for the Cisco XR 12000 Router, Release 4.3.x
show tech-support routing ospf
Operations
read
271