Show Tech-Support Mpls Traffic-Eng - Cisco XR 12000 Command Reference Manual

show tech-support mpls traffic-eng

show tech-support mpls traffic-eng
To automatically run show commands that display information specific to Multiprotocol Label Switching
(MPLS) Traffic Engineering (TE) debugging, use the show tech-support mpls traffic-eng command in
EXEC mode.
show tech-support mpls traffic-eng {terminal [page]| file send-to [background] [compressed|
uncompressed]} [forwarding tunnel-name tunnel name] [tunnel-number number]
Syntax Description
file
send-to
background
compressed
uncompressed
forwarding
tunnel-name
tunnel name
terminal
Cisco IOS XR Advanced System Command Reference for the Cisco XR 12000 Router, Release 4.3.x
224
Specifies that the command output is saved to a specified file.
Name of the file. The following valid options are listed:
• filename
• bootflash: filename
• disk0: filename
• disk0a: filename
• disk1: filename
• disk1a: filename
• ftp: filename
• harddisk: filename
• harddiska: filename
• harddiskb: filename
• nvram: filename
• rcp: filename
• tftp: filename
(Optional) Specifies that the command runs in the background.
(Optional) Displays compressed command output.
(Optional) Displays the command output with no compression.
(Optional) Displays forwarding information for a tunnel.
Specifies the tunnel name that is used by the RSVP process.
Name for the tunnel.
Specifies that the command output is displayed on the terminal.
Tech-Support Commands
OL-28456-02