Cisco XR 12000 Command Reference Manual page 272

show tech-support routing isis
Command Default
The command output is not compressed.
Command Modes
EXEC
Command History
Release
Release 3.2
Usage Guidelines
This command can generate a very large amount of output. You may want to redirect the output to a file
Tip
using the file send-to keyword and argument. Redirecting the output to a file also makes sending the
output to your Cisco Technical Support representative easier.
Use the show tech-support isis command to run show commands that display information specific to IS-IS
debugging. This command generates IS-IS debugging information that can be useful for Cisco Technical
Support representatives when troubleshooting a router. See 'Obtaining Documentation and Submitting a
Service Request' section on page iii in the Preface for Cisco Technical Support contact information.
This command is not required during normal use of the router.
Note
The following show commands run automatically when you run the show tech-support routing isis
command:
• show isis trace all location all
• show isis all
• show clns statistics
• show imds interface all
• show ipv4 int brief
• show ipv6 int brief
• show route ipv4
• show route ipv6
• show inst which comp clns-isis
See the Cisco IOS XR software command references for information about these commands and descriptions
of their command output. The Cisco IOS XR software command references are located at the following URL:
http://www.cisco.com/en/US/products/ps5845/prod_command_reference_list.html
Cisco IOS XR Advanced System Command Reference for the Cisco XR 12000 Router, Release 4.3.x
264
Modification
This command was introduced.
Tech-Support Commands
OL-28456-02