Show Controllers Pse Qfp System State - Cisco XR 12000 Command Reference Manual

show controllers pse qfp system state

show controllers pse qfp system state
To display packet switching engine (PSE) QFP HA state information for a specific node, use the show
controllers pse qfp system state command in EXEC mode.
show controllers pse qfp system state [location node-id]
Syntax Description
location node-id
Command Default
None.
Command Modes
EXEC
Command History
Release
Release 3.9.0
Usage Guidelines
Task ID
Task ID
interface
cisco-support
Examples The following command shows how to run the show controllers pse qfp system state command:
RP/0/0/CPU0:router# show controllers pse qfp system state location 0/1/cpu0
Cisco IOS XR Advanced System Command Reference for the Cisco XR 12000 Router, Release 4.3.x
28
(Optional) Identifies the location of the node whose PSE device information you
want to display. The node-id argument is expressed in the rack/slot/module notation.
Use the show platform command to see the location of all nodes installed
Note
in the router.
Modification
This command was introduced.
ASIC Driver Commands
Operations
read
read
OL-28456-02