Show Tech-Support Mpls Rsvp - Cisco XR 12000 Command Reference Manual

show tech-support mpls rsvp

show tech-support mpls rsvp
To automatically run show commands that display information specific to Multiprotocol Label Switching
(MPLS) Resource Reservation Protocol (RSVP) debugging, use the show tech-support mpls rsvp command
in EXEC mode.
show tech-support mpls rsvp {terminal [page]| file send-to [background] [compressed| uncompressed]}
Syntax Description
terminal
page
file
sent-to
background
compressed
uncompressed
Cisco IOS XR Advanced System Command Reference for the Cisco XR 12000 Router, Release 4.3.x
218
Displays the command output on the terminal.
(Optional) Displays the command output on a single page at a time. Use the Return
key to display the next line of output or use the space bar to display the next page
of information. If not used, the output scrolls (that is, it does not stop for page
breaks).
Press the Ctrl-C keys to stop the command output.
Specifies that the command output is saved to a specified file.
Name of the file. The following valid options are listed:
• filename
• bootflash: filename
• compactflash: filename
• disk0: filename
• disk1: filename
• flash: filename
• ftp: filename
• harddisk: filename
• harddiska: filename
• nvram: filename
• rcp: filename
• slot0: filename
• slot1: filename
• tftp: filename
(Optional) Specifies that the command runs in the background.
(Optional) Displays compressed command output.
(Optional) Displays the command output with no compression.
Tech-Support Commands
OL-28456-02