Cisco XR 12000 Command Reference Manual page 17

ASIC Driver Commands
SPA allocated Rx buffer size
SPA available Rx buffer size
RxSPI PLL reset
Header Format type
Pad bytes
L2LA
Strict priority mode
EFC Manager
SPA dual wide mode
Max SPA channels
PLIM loopback
SPI loopback
DatamaxT
Training M
DIP2 Match
DIP2 Error
Tx SClk edge
DIP4 Match
DIP4 Error
Rx SClk edge
SPI bus speed
Tx Burst size
Rx Burst size sysdb
Rx SPI state
Rx SPI sync state
Rx calendar mode
Maximun RxSPI channels
Tx SPI state
Tx SPI sync state
Tx calendar mode
Maximun Tx SPI4.2 channels
This table describes the significant fields shown in the display.
Table 4: show controllers plim asic spa bay Field Descriptions
Field
SPA OIR state
SPA state
SPA allocated Rx buffer size
SPA available Rx buffer size
RxSPI PLL reset
Header Format type
Pad bytes
L2LA
OL-28456-02
: 4MB
: 0x20c000
: inactive
: Format A
: 0
: 0
: active
: disabled
: inactive
: 10
: inactive
: inactive
: 4096
: 16
: 3
: 3
: falling
: 15
: 2
: rising
: 350MHz
: 64 Bytes
: 80 Bytes
: enabled
: inframe
: single
: 10
: enabled
: inframe
: single
: 5
Cisco IOS XR Advanced System Command Reference for the Cisco XR 12000 Router, Release 4.3.x
show controllers plim asic spa bay
Description
3
Current OIR status for this SPA.
Current state of the specified SPA. Can be enabled
or disabled.
Number of bytes allocated for the receive buffer.
Number of bytes available in the receive buffer.
SPI PLL receive timer reset value.
Header format used by this ASIC.
Number of pad bytes allowed to fill out the packets
sent on this ASIC.
Layer 2 Length Adjust. When a length entry has been
read or is being written, this bit contains the value of
the L2LA field.
9