Cisco XR 12000 Command Reference Manual page 18

show controllers plim asic spa bay
Field
Strict priority mode
EFC Manager
SPA dual wide mode
Max SPA channels
PLIM loopback
SPI loopback
DatamaxT
Training M
DIP2 Match
DIP2 Error
Tx SClk edge
DIP4 Match
Cisco IOS XR Advanced System Command Reference for the Cisco XR 12000 Router, Release 4.3.x
10
Description
Indicates whether strict priority mode is active or
inactive on this SPA.
Strict priority mode ensures that the Priority Queue
is serviced only when it is not empty. This provides
the lowest possible delay for matching traffic.
4
Indicates whether the EFC
disabled on this SPA.
Indicates whether dual wide mode is active or inactive
on this SPA.
Maximum channels supported on this SPA.
Indicates whether loopback is active or inactive on
this SPA.
Indicates whether SPI loopback is active or inactive
on this SPA.
Maximum data training interval. This is the maximum
interval between scheduling of training sequences on
5
the SPI data path. If the DatamaxT field shows 0,
then the core never sends periodic training.
Number of consecutive DIP2
Tstat bus before the TxSPI module enters the
out-of-frame state. This signal can be safely set at any
time.
Total number of 2-bit DIP2 packets that met specific
match clauses.
Note DIP2 is a parity algorithm where a 2-bit odd
parity is computed diagonally over status
words.
Total number of 2-bit DIP2 errors
DIP2 is a parity algorithm where a 2-bit odd
Note
parity is computed diagonally over status
words.
Indicates which edge of the transmit SClk to use to
sample the Tstat bus. Selects rising or falling edge as
the active transmit SClk edge.
Total number of 2-bit DIP4 packets that met specific
match clauses.
ASIC Driver Commands
manager is enabled or
6
errors detected on the
OL-28456-02