Applying Standby Power To The Server - HPE Integrity rx2800 i2 series User's & Service Manual

Table 7: Power states
Power states
Standby power
Full power
Off
NOTE:
If the power restore feature is set to Always On through the iLO 3 MP PR command, the server
automatically powers on to the full power state when the power cord is plugged in to the server.
CAUTION:
If the server is expected to remain in standby mode for more than 30 minutes, Hewlett Packard
Enterprise recommends completely removing AC power from the server. You can do this by
switching off the circuit breakers that are part of the building installation, disconnecting or switching
off a power distribution unit, or by physically removing the power cords from the server.
Be aware that removing AC power from the server for an extended period can drain the system
battery.
HPE Integrity rx2800 i2 Server User Service Guide shows the ports and power supplies located on the
rear panel of the server.

Applying standby power to the server

Procedure
1. Plug the power cord into the receptacle in power supply.
2. Plug the other end of the power cord into an AC outlet.
NOTE:
The LED on the power supply does not illuminate in the standby power state. The LED is green
when the server is powered on to full power.
If the power restore feature is set to Always On through the iLO 3 MP PR command, the server
automatically powers on to the full power state when the power cord is plugged into the server.
3. If the server has two power supplies, plug the second power cord into the power supply.
4. Plug the other end of the power cord into an AC outlet.
Connecting to the LAN
The server has four LAN ports that provide network connectivity. The HPE Integrity rx2800 i2 Server User
Service Guide shows the available LAN ports for the server.
34 Applying standby power to the server
Power activated through the iLO 3
Power cable
PC command; or front panel
plugged into
power button activated?
receptacle?
Yes No
Yes Yes
No No
Standby DC DC voltage
voltage applied?
applied?
Yes No
Yes Yes
No No