HPE Integrity rx2800 i2 series User's & Service Manual page 122

Table 38: I/O card events that might illuminate SID LEDs
Diagnostic Sample IPMI Events
LEDs
I/O Card Type E0h, 4658d:26d
IO_PCI_POWER_OVERLOAD_ERR
I/O Card Type E0h, 137d:26d
IO_NOT_ENOUGH_POWER_ERROR
I/O Card Type E0h, 147d:26d
IO_SLOT_STANDBY_POWER_ERROR
I/O Card Type E0h, 131d:26d
IO_HOT_PLUG_CTRL_FAILED
I/O Card Type E0h, 139d:26d
IO_PCI_MAPPING_TOO_BIG
I/O Card Type E0h, 148d:26d
IO_UNKNOWN_PCIXCAP_VAL
I/O Card Type E0h, 141d:26d
IO_PCIXCAP_SAMPLE_ERROR
I/O Card Type E0h, 123d:26d
IO_CHECK_LBA_MISSING_ERR
I/O Card Type E0h, 619d:26d
IO_CHECK_LBA_DECONFIG_ERR
122 Troubleshooting
Cause Source Notes
A non hot plug I/O SFW
slot power
consumption
increases the total
I/O power
consumption beyond
the supported limit
Insufficient power to SFW
power on a hot-plug
PCI-X slot
PCI slot standby SFW
power failed
PCI-X hot-plug SFW
controller failed
PCI bus walk (I/O SFW
discovery) resources
exceeded
Found invalid SFW
PCIXCAP value
PCIXCAP sampling SFW
error
Expected I/O host SFW
bridge (Lower Bus
Adapter) is missing
Expected I/O host SFW
bridge (Lower Bus
Adapter) is
deconfigured
Disallow O/S
boot and
display the
following UEFI
error message,
"I/O
configuration
exceed"
Display UEFI
warning
message
"Failed I/O
slots
deconfigured"
Either a card /
slot issue. Re-
seat card first.
Either a card /
slot issue. Re-
seat card first.
Remove any
unsupported
I/O cards.
Move I/O card
to an unused
PCI slot
Table Continued