Hard Drive Leds - HPE Integrity rx2800 i2 series User's & Service Manual

Table 20: SEL LED states
Definition
System is off, or system is booting firmware with no failures, since
SEL logs last examined.
System has left the firmware boot, and an OS is booting or running
with no failures, since SEL logs last examined.
A fatal fault has been detected and logged.
The iLO 3 MP displays the following strings in its Virtual Front Panel for the states of this LED:
Table 21: VFP health description
Off
On green
Flashing red

Hard drive LEDs

The hard drives have two LEDs per drive. See Hot-plug SAS disk drive LEDs :
Drive status LED
The drive status LED can appear amber or blue.
• Amber indicates a warning, or failure condition.
• Blue is a locator LED that identifies a particular disk drive.
Various software utilities, such as online diagnostics or SAS disk drive configuration tools, can
activate the locator LED.
Drive activity LED
The drive activity LED is solid green during normal operation and flashes green when a drive is
accessed.
Figure 17: Hot-plug SAS disk drive LEDs
1. Drive status LED (locator LED)
2. Drive activity LED
<none>
OS booting or running
Fatal fault -- system crashed or cannot boot: check logs for details
Flash Rate LED Color
LED Off
Steady Green
Flash 2 Hz Red
Troubleshooting 97