Os Login Prompt - HPE Integrity rx2800 i2 series User's & Service Manual

OS login prompt

If your server is at the OS login prompt after you establish a connection to the server, use your standard
OS log in procedures, or see your OS documentation for the next steps.
Powering on and powering off the server
Power states
The server has the following power states:
• Standby power
• Full power
• Off
For details about server power states, see Power states.
NOTE:
If the power restore feature is set to Always On through the iLO 3 MP PR command, the server
automatically powers on to the full power state when the power cord is plugged in to the server.
Powering on the server
Power on the server to full power using the following methods if the server is in the standby power state:
• iLO 3 MP PC command
• Power button
Powering on the server using the iLO 3 MP
NOTE:
If the power restore feature is set to
Always On through the iLO 3 MP PR command, the server automatically powers on to the full
power state when the power cord is plugged in to the server.
Procedure
1. Plug all power cables into the receptacles on the rear panel of the server.
2. Initiate a console session, and access the MP Main Menu.
3. Enter CM to enable command mode.
4. Enter PC to use the remote power control command.
5. Enter ON to power on the server, and enter YES when prompted to confirm the action.
6. Start the operating system.
7. For more information, see the operating system documentation.
40 OS login prompt