Front Panel Leds - HPE Integrity rx2800 i2 series User's & Service Manual

Front panel LEDs

Table 14: Front panel controls
Name Function
UID button This button helps locate a particular server
within a rack of servers. You can remotely
activate this function through various system
utilities.
System This LED provides information about the
health LED system status.
Power This button manually powers the server on
button and off.
The front panel of the system contains the power button/system power LED, health LED, System Event
Log LED, and locator switch/LED. The server use flashing states (for example, flashing amber or red) on
these LEDs to indicate a warning or an error.
There are a total of three LEDs, arranged vertically, with the UID button and the power button each having
an integrated LED. In addition to the two integrated button/LEDs, there is a health LED.
92 Front panel LEDs
Status
• Blue = Identification
• Flashing blue = Remote iLO session or a
firmware flash update is in progress
• Off = Off
• Green = Health good on all internal FRUs
and system firmware has passed
"BOOT_START"
• Flashing Amber = A FRU or subsystem
has failed, or a fatal fault has occurred
(system is on or in standby mode).
• Flashing Red = A fatal fault has been
detected and a FRU or subsystem has
failed. View the SID, other LEDs, and the
logs for information.
• Off = Health good on all internal FRUs
and system off
NOTE:
The System Health LED does not
change status if AC power is removed
from a single power supply in a
rx2800 i2 server system with power
redundancy.
• Green = System on
• Amber = System is powered off, but
standby power is on
• Off = System power and standby power
is off