HPE Integrity rx2800 i2 series User's & Service Manual page 44

NOTE: If you do not see a line starting with Port and ending with (SAS), the tape is not
connected correctly or it is not responding.
5. Locate the device you want to boot from.
a. For DVD, locate the device:
I. To list all device names from the UEFI Shell prompt, use the map command.
II. From the list generated by the map command, locate the device name (in this example, fs6).
III.
fs2:\> map
Device mapping table
fs6
IV.
V. At the UEFI shell prompt, specify the device name for the DVD-ROM.
VI. Enter the appropriate UEFI install command, as in the following example:
VII. HP-UX
Shell> fs6:
fs6:\> install
OpenVMS
Shell> fs0:
fs0:\> cd efi\boot
fs0:\efi\boot> bootia64
b. For tape, locate the device:
I. To boot from tape once you are at the UEFI shell:
II.
Shell> tapeboot select
01 PcieRoot(0x30304352)/Pci(0x8,0x0)/Pci(0x0,0x0)/
SAS(0x50060B00007F6FFC,0x0,0x1,NoTopology,0,0,0,0x0)
Select Desired Tape:
• If the correct media is installed, it will boot from tape when you enter the index number.
• If there is no media in the SAS tape drive and you select 1, the following message appears:
tapeboot: Could not load tapeboot image
6. The operating system starts loading onto the server.
7. To complete the OS installation, follow the on-screen instructions.
8. Once the installation has completed, review the Configuring system boot options on page 45.
44 Operating system procedures
:Removable CDRom - Alias cd66d0a blk6
PcieRoot(0x30304352)/Pci(0x1D,0x7)/USB(0x3,0x0)/CDROM(0x0)
NOTE:
Your DVD drive might not be named fs6. Make sure that you verify the ID appropriate
to your DVD device.
01 <<input 01