Diagnostics - HPE Integrity rx2800 i2 series User's & Service Manual

Name
NIC/iLO 3 link LED
iLO 3 physical
presence pinhole
button
Power supply
The server is equipped with one or two power supplies, labeled PS1 and PS2. Each power supply has an
AC power input receptacle and an LED that indicates the power state of the server.
The server has the following power states: standby power, full power, and off. To achieve the standby
power state, plug the power cord into the appropriate receptacle at the rear of the server. To achieve full
power, plug the power cord into the appropriate receptacle, and either push the power button or enter the
iLO 3 MP PC command. In the off state, the power cords are not connected to a power source.
Table 25: Power supply LED states
LED state
Off
Green

Diagnostics

A suite of offline and online support tools are available to enable manufacturing, field support personnel,
and the customer to troubleshoot system issues. In general, if the operating system is already running,
Status
• Green = Network link
• Off = No network link
The iLO 3 physical presence button enables you to reset iLO 3 and gain access
to the system if all iLO passwords are lost. A momentary press causes a soft
reset of iLO 3 when the button is released. The iLO 3 Physical Presence button
enables you to reset iLO, enter TPM physical presence mode, and enter security
override mode.
• A momentary press of the button resets iLO, clears any security override or
TPM physical presence mode that were initiated by this button, and returns
the serial port to iLO mode.
• A greater than 4-second and less than 8-second press of the button places
the system in physical presence mode for up to 15 minutes.
• A greater than 8-second and less than 12-second press of this button places
iLO into security override mode for up to 15 minutes. Security override mode
enables you to enter iLO without being challenged for a password enabling
you to set up users.
• The UID LED blinks once after holding the button for 4 seconds and once
after holding the button for 8 seconds to help you gauge how long the button
press has been held.
NOTE:
The iLO 3 physical presence pinhole button is located behind the sheet
metal grill and the circular punch-out in the rear panel.
Indication
No AC power
Full power on; normal operation
Diagnostics 101