Removing And Replacing The System Board - HPE Integrity rx2800 i2 series User's & Service Manual

To replace the component, reverse the removal procedure.

Removing and replacing the system board

IMPORTANT:
If your system board has a TPM installed, you must order a new TPM when you order a
replacement system board.
Before replacing the system board, you must first back up the current TPM settings. See the HP-UX
operating system documentation for more information.
The TPM is not a customer-installable component. If you need to replace a TPM on a replacement
system board, contact a Hewlett Packard Enterprise authorized service provider.
WARNING:
Once the TPM is installed on your system board, it cannot be removed. If the TPM fails, the system
board needs to be replaced. Attempting to remove the TPM from the system board will void any
existing Hewlett Packard Enterprise service contract and cause the server to fail.
Procedure
1. Power off the server (Powering off the server).
2. Remove all power supplies (Removing and replacing a hot-swap power supply on page 146).
3. Remove all hot-plug hard drives (Removing and replacing a hot-plug SAS hard drive).
4. Extend or remove the server from the rack (Removing the server from the rack on page 139) or
Extending the server from the rack).
5. Remove the access panel (Removing the access panel).
6. Remove the air baffle.
Removing and replacing the system board 171