Auto-Voip Priority; Show Auto-Voip - TP-Link JetStream T3700G-52TQ Cli Reference Manual

T3700G-52TQ JetStream 52-Port Gigabit Stackable L3 Managed Switch CLI Guide
Example
Allow packets to be sent on unauthorized Auto VoIP port 3:
T3700G-52TQ(config)# interface gigabitEthernet 1/0/3
T3700G-52TQ(config-if)# auto-voip auth enable

52.8 auto-voip priority

Description
The auto-voip data priority command is used to configure the switch to trust
the CoS value in the arriving packet or not.
Syntax
auto-voip data priority { trust | untrust }
Parameter
trust——The switch trusts the CoS value in the arriving packet.
untrust——The switch ignores the CoS value in the arriving packet.
Command Mode
Interface Configuration Mode (interface gigabitEthernet / interface range
gigabitEthernet )
Example
Configure the switch to trust the CoS value in the arriving packet on port 3:
T3700G-52TQ(config)# interface gigabitEthernet 1/0/3
T3700G-52TQ(config-if)# auto-voip data priority trust

52.9 show auto-voip

Description
The show auto-voip command is used to display the Auto VoIP configuration
information.
Syntax
show auto-voip [ interface ]
469