Single-Rate - TP-Link JetStream T3700G-52TQ Cli Reference Manual

T3700G-52TQ JetStream 52-Port Gigabit Stackable L3 Managed Switch CLI Guide
cos
from 0 to 7.
dscp
prec
Command Mode
Policy-Class-Map Configuration Mode
Example
Enter the Policy-Map Config mode for a policy named tp, then add a class
named market to the policy and enter Policy-Class-Map Configuration Mode.
Set the token's generation rate as 1000 Kbps, the maximum capacity of the
token bucket as 100 Kbytes, transmit the conforming traffic and drop the
nonconforming traffic:
T3700G-52TQ(config)#policy-map tp
T3700G-52TQ(config-pmap)#class market
T3700G-52TQ(config-pmap-c)#simple 1000 100 conform transmit violate
drop

25.37 single-rate

Description
The single-rate command is used to configure single-rate traffic policing
action.
Syntax
single-rate
set-cos-transmit | set-dscp-transmit | set-prec-transmit | transmit } [
dscp
set-dscp-transmit | set-prec-transmit | transmit } [
{ drop |
set-prec-transmit | transmit } [
Parameter
CIR ——
ranges from 1 to 1000000.
CBS ——
ranges from 1 to 128.
—— The Class of Service(Cos) value in an Ethernet frame header, ranging
—— Enter a DSCP value in the range of 0 to 63.
—— Enter an IP precedence value in the range of 0 to 7.
CIR CBS EBS
conform { drop |
prec
| ] exceed { drop |
set-cos-as-sec-cos
Specify the token's generation rate in Kbps for token bucket C. It
Specify the maximum capacity in Kbytes for token bucket C. It
set-cos-as-sec-cos
set-cos-as-sec-cos
| set-cos-transmit |
| set-cos-transmit | set-dscp-transmit |
cos dscp prec
| | ]
204
|
cos
cos dscp prec
| | ] violate
|