Auto Voip; Auto Voip Config - TP-Link T3700G-28TQ User Manual

Choose the menu QoS→Voice VLAN→OUI Config to load the following page.
Configuration Procedure:
1) Enter an OUI address and give a description about the OUI address.
2) Click Create to add an OUI address to the table.
Entry Description:
OUI:
Description:

12.5 Auto VoIP

Overview

The Auto VoIP feature is used to prioritize the transmission of voice traffic. Voice over Internet
Protocol (VoIP) enables telephone calls over a data network, and the Auto VoIP feature helps
provide a classification mechanism for voice packets. When Auto VoIP is configured on a port
that receives both voice and data traffic, this feature can help ensure that the sound quality of
an IP phone does not deteriorate when data traffic on the port is heavy.
To apply the Auto VoIP configuration, you need to further configure LLDP and DiffServ. For
LLDP
details, see and

12.5.1 Auto VoIP Config

Before configuring Auto VoIP, you need to create a VLAN for voice traffic. For details about
VLAN configuration, see
Figure 12-21 OUI Config
Enter the OUI address of your device.
Give an OUI address description for identification. The length is
no more than 16 characters.
DiffServ
.
802.1Q VLAN
.
319