TP-Link JetStream T3700G-52TQ Cli Reference Manual page 279

T3700G-52TQ JetStream 52-Port Gigabit Stackable L3 Managed Switch CLI Guide
Syntax
ip igmp
max-response-time
interface { fastEthernet
port
| port-channel
no ip
max-response-time | rtime | mtime | rport interface { fastEthernet
gigabitEthernet
port-channel-id
Parameter
vlan-list
from 1 to 4093, in the format of 1-3, 5.
immediate-leave —— Configure the Fast Leave function.
max-response-time
ranging from 1 to 25. The default aging time is 10 seconds.
rtime
—— Specify the aging time in seconds, ranging from 0 to 3600. The
default aging time is 0 second.
mtime
default aging time is 260 seconds.
port
—— Static Router Port, which is mainly used in the network with stable
topology.
port-channel-id
report-suppression —— Enable the IGMP report suppression function.
When it is enabled, the switch forwards only the first IGMP report message
per mulicast group to the Layer 3 device, and the subsequent IGMP reports
from the same multicast group are discarded.
Command Mode
Global Configuration Mode
Example
Enable the IGMP Snooping function and modify Member Port Time as 200
seconds for VLAN1-3:
T3700G-52TQ(config)#ip igmp snooping vlan-config 1-3 mtime 200
snooping vlan-config
max-response-time
port
port-channel-id
igmp snooping
port
|
} | report-suppression ]
—— The ID list of the VLAN desired to modify configuration, ranging
—— Specify the maximum responding time in seconds,
—— Specify the aging time in seconds, ranging from 2 to 3600. The
—— The ID of the port channel.
vlan-list
rtime
| rtime
| gigabitEthernet
} | report-suppression ]
vlan-list
vlan-config
ten-gigabitEthernet
256
[ immediate-leave
mtime
| mtime | rport
port
| ten-gigabitEthernet
[ immediate-leave
port
| port-channel
|
|
port
|