Bandwidth - TP-Link JetStream T3700G-52TQ Cli Reference Manual

T3700G-52TQ JetStream 52-Port Gigabit Stackable L3 Managed Switch CLI Guide
Parameter
broadcast —— The Broadcast control function allows the switch to filter
broadcast in the network. If the transmission rate of the broadcast packets
exceeds the set bandwidth, the packets will be automatically discarded to
avoid network broadcast storm.
multicast —— Multicast control function allows the switch to filter multicast in
the network. If the transmission rate of the multicast packets exceeds the set
bandwidth, the packets will be automatically discarded to avoid network
broadcast storm.
unicast —— Unicast control function allows the switch to filter UL frame in
the network. If the transmission rate of the UL frames exceeds the set
bandwidth, the packets will be automatically discarded to avoid network
broadcast storm.
kbps | ratio | pps —— Specify the unit of measurement of the storm control
function.
rate
traffic exceeding the bandwidth will be discarded. Range: 1 to 1000000 kbps
for the gigabit port, 1 to 10000000 kbps for the ten-gigabit port.
Command Mode
Interface Configuration Mode (interface gigabitEthernet / interface range
gigabitEthernet
ten-gigabitEthernet)
Example
Enable the broadcast control function for Gigabit Ethernet port 1/0/5 and set
the bandwidth for receiving broadcast packets as 256 kbps:
T23700G-52TQ(config)#interface gigabitEthernet 1/0/5
T3700G-52TQ(config-if)#storm-control broadcast kbps 256

23.12 bandwidth

Description
The bandwidth command is used to configure the bandwidth limit for an
Ethernet port. To disable the bandwidth limit, please use no bandwidth
command.
—— Specify the bandwidth for receiving packets on the port. The packet
/ interface ten-gigabitEthernet
169
/ interface range