Jumbo - TP-Link JetStream T3700G-52TQ Cli Reference Manual
52-port gigabit stackable l3 managed switch
Hide thumbs
Also See for JetStream T3700G-52TQ:
- User manual (426 pages) ,
- Installation manual (37 pages) ,
- User manual (430 pages)
Table of Contents
Advertisement
T3700G-52TQ
JetStream 52-Port Gigabit Stackable L3 Managed Switch CLI Guide
default the Gigabit Ethernet port is auto-negotiation mode and the Ten
Gigabit Ethernet port is full-dulplex mode.
Command Mode
Interface Configuration Mode (interface gigabitEthernet / interface range
gigabitEthernet
ten-gigabitEthernet)
Example
Configure the Duplex Mode as full-duplex for Gigabit Ethernet port 1/0/20:
T3700G-52TQ(config)#interface gigabitEthernet 1/0/20
T3700G-52TQ(config-if)#duplex full
23.9 jumbo
Description
The jumbo command is used to configure the value of MTU, allowing the port
to send jumbo frames. To return to the default configuration, please use no
mtu command. The default MTU is 1518 bytes.
Syntax
mtu
no mtu
Parameter
number
port. The valid value ranges from 1518 to 13312.
Command Mode
Interface Configuration Mode (interface gigabitEthernet / interface range
gigabitEthernet
ten-gigabitEthernet)
Example
Configure the MTU as 12288 for Gigabit Ethernet port 1/0/20:
T3700G-52TQ(config)#interface gigabitEthernet 1/0/20
T3700G-52TQ(config-if)#mtu 12288
/
interface
number
—— The length of the frame that is allowed to be transmitted on the
/
interface
ten-gigabitEthernet
ten-gigabitEthernet
167
/
interface
range
/
interface
range
Advertisement
Table of Contents
