Chapter 42 Pim Commands; Ip Multicast-Routing; Ip Pim (Global) - TP-Link JetStream T3700G-52TQ Cli Reference Manual

T3700G-52TQ JetStream 52-Port Gigabit Stackable L3 Managed Switch CLI Guide

Chapter 42 PIM Commands

The Protocol Independent Multicast (PIM) protocol is multicast routing protocol which uses
unicast routing information to perform the multicast forwarding function in the three-layer
network. PIM can operate in dense mode or sparse mode.

42.1 ip multicast-routing

Description
The ip multicast-routing command is used to enable ip multicast routing
function. To disable the ip multicast routing function and delete all the
multicast routing entries, please use no ip multicast-routing command.
Syntax
ip multicast-routing
no ip multicast-routing
Command Mode
Global Configuration Mode
Example
Enable the IP multicast routing function globally:
T3700G-52TQ(config)#ip multicast-routing

42.2 ip pim (global)

Description
The ip pim command is used to configure PIM mode globally. To disable the
PIM DM or SM mode, please use no ip pim command.
Syntax
ip pim {dense-mode | sparse-mode}
no ip pim [dense-mode | sparse-mode]
Parameter
dense-mode —— Enable PIM with dense mode.
sparse-mode —— Enable PIM with sparse mode.
366