Lldp Receive - TP-Link JetStream T3700G-52TQ Cli Reference Manual

T3700G-52TQ JetStream 52-Port Gigabit Stackable L3 Managed Switch CLI Guide
Syntax
lldp timer { tx-interval
notify-interval
no lldp timer { tx-interval | reinit-delay | notify-interval }
Parameter
tx-interval
to its neighbors. The value ranges from 5 to 32768 and the default value is 30
seconds.
reinit-delay
LLDP status becomes "disable" until re-initialization will be attempted. The
value ranges from 1 to 10 and the default value is 2 seconds.
notify-interval
from local device to network management system. The value ranges from 5
to 3600 and the default value is 5 seconds.
Command Mode
Global Configuration Mode
Example
Specify the Transmit Interval of LLDPDU as 45 seconds and Trap message to
NMS as 120 seconds:
T3700G-52TQ(config)#lldp timer tx-interval 45
T3700G-52TQ(config)#lldp timer notify-interval 120

36.3 lldp receive

Description
The lldp receive command is used to enable the designated port to receive
LLDPDU. To disable the function, please use no lldp receive command.
Syntax
lldp receive
no lldp receive
Command Mode
Interface Configuration Mode (interface fastEthernet / interface range
fastEthernet / interface gigabitEthernet / interface range gigabitEthernet/
interface ten-gigabitEthernet / interface range ten-gigabitEthernet)
tx-interval |
}
—— Configure the interval for the local device to transmit LLDPDU
—— This parameter indicates the amount of delay from when
—— Specify the interval of Trap message which will be sent
312
reinit-delay |
reinit-delay notify-interval