Passive-Interface - TP-Link JetStream T3700G-52TQ Cli Reference Manual
52-port gigabit stackable l3 managed switch
Hide thumbs
Also See for JetStream T3700G-52TQ:
- User manual (426 pages) ,
- Installation manual (37 pages) ,
- Installation manual (28 pages)
Table of Contents
Advertisement
T3700G-52TQ
JetStream 52-Port Gigabit Stackable L3 Managed Switch CLI Guide
no compatible rfc1583
Command Mode
Router Configuration Mode
Example
Configure the OSPF's compatibility for the routing rules in RFC 1583:
T3700G-52TQ(config)# router ospf 1
T3700G-52TQ(config-router)# compatible rfc1583
46.12 passive-interface
Description
The passive-interface command is used to prevent an interface from
sending OSPF packets. To restore to the default settings, please use no
passive-interface command. The interface is allowed to send OSPF packets
by default.
Syntax
passive-interface { { fastEthernet | gigabitEthernet | ten-gigabitEthernet }
port
no
ten-gigabitEthernet }
Parameter
fastEthernet | gigabitEthernet | ten-gigabitEthernet —— The port type of the
interface.
port
id
—— The interface loopback ID.
vlan-id
Command Mode
Router Configuration Mode
Example
Prevent interface VLAN 1 from sending OSPF packets in routing process 1:
T3700G-52TQ(config)# router ospf 1
id
vlan-id
| loopback
| vlan
passive-interface
port
—— The port number.
—— The interface VLAN ID.
}
{
{ fastEthernet
id
vlan-id
| loopback
| vlan
407
|
gigabitEthernet
}
|
Advertisement
Table of Contents
