Switchport Pvid; Switchport Trunk Native Vlan - TP-Link JetStream T3700G-52TQ Cli Reference Manual
52-port gigabit stackable l3 managed switch
Hide thumbs
Also See for JetStream T3700G-52TQ:
- User manual (426 pages) ,
- Installation manual (37 pages) ,
- Installation manual (28 pages)
Table of Contents
Advertisement
T3700G-52TQ
JetStream 52-Port Gigabit Stackable L3 Managed Switch CLI Guide
4.8 switchport pvid
Description
The switchport pvid command is used to configure the PVID for the switch
General ports. To restore the PVID of the specified port as 1, please use the
no switchport pvid.
Syntax
switchport pvid
Parameter
vlan-id
Command Mode
Interface Configuration Mode (interface fastEthernet / interface range
fastEthernet / interface gigabitEthernet / interface range gigabitEthernet/
interface ten-gigabitEthernet / interface range ten-gigabitEthernet)
Example
Specify the PVID of Gigabit Ethernet port 1/0/3 (General) as 1:
T3700G-52TQ(config)#interface gigabitEthernet 1/0/3
T3700G-52TQ(config-if)#switchport pvid 1
4.9 switchport trunk native vlan
Description
The switchport trunk native vlan command is used to configure the PVID for
the switch Trunk ports. To restore the PVID of the specified port as 1, please
use the no switchport trunk native vlan.
Syntax
switchport trunk native vlan
Parameter
vlan-id
vlan-id
—— Specify IEEE 802.1Q VLAN ID, ranging from 1 to 4093.
—— Specify IEEE 802.1Q VLAN ID, ranging from 1 to 4093.
vlan-id
35
Advertisement
Table of Contents
