Auto-Voip None; Auto-Voip Auth - TP-Link JetStream T3700G-52TQ Cli Reference Manual
52-port gigabit stackable l3 managed switch
Hide thumbs
Also See for JetStream T3700G-52TQ:
- User manual (426 pages) ,
- Installation manual (37 pages) ,
- User manual (430 pages)
Table of Contents
Advertisement
T3700G-52TQ
JetStream 52-Port Gigabit Stackable L3 Managed Switch CLI Guide
52.6 auto-voip none
Description
The auto-voip none command is used to instruct voice devices to send
untagged packets based on settings of themselves.
Syntax
auto-voip none
Command Mode
Interface Configuration Mode (interface gigabitEthernet / interface range
gigabitEthernet )
Example
Instruct voice devices that are connected to port 3 to send untagged packets
based on settings of themselves:
T3700G-52TQ(config)# interface gigabitEthernet 1/0/3
T3700G-52TQ(config-if)# auto-voip none
52.7 auto-voip auth
Description
The auto-voip auth command is used to allow packets to be sent on
unauthorized ports or not.
Syntax
auto-voip auth { disable | enable }
Parameter
enable——Packets are permitted on unauthorized Auto VoIP ports.
disable——Packets are denied on unauthorized Auto VoIP ports.
Command Mode
Interface Configuration Mode (interface gigabitEthernet / interface range
gigabitEthernet )
468
Advertisement
Table of Contents
